I’m the first to admit that I’m not one to make up my own patterns, but I *kind of* did here.
When Munchkin was a baby, we had a receiving blanket from Old Navy (it was a gift) that was much nicer than the “normal” ones from the less expensive stores. It was two-sided for one thing, and made of nicer, thicker material for another. I took that basic idea and put this one together. I also took pictures along the way so I could share with you how to do it should you want to make one.
1. Cut your fabric. You’ll need two pieces each about 35-37 inches square, depending on how big you want your finished blanket to be. You can use the same pattern or a different one for front and back; it’s entirely up to you. I cut mine about 37″ because I just have a gut feeling that Small Fry is going to be bigger than either of his brothers. Time will tell on that account :).
2. Using anything round (you can see that I just used a can of water chestnuts) to round the corners. Mark around the can (or other item) with a marking pencil. Do this on all 4 corners of both pieces of fabric.
3. Cut along the lines of all 8 corners.
4. Pin your front and back to each other, right sides together.
5. Sew a quarter-inch seam all the way around, leaving just enough room to turn it right side out. 4-6 inches should be enough, but if you’re worried about it, you can always leave more.
6. Clip the rounded corners. Turn.
7. Press the edges so they’re nice and crisp. (Yes, my ironing board consists of a towel laid out on my table. We try to only have things in our house that are multipurpose, and an ironing board doesn’t meet that qualification.)
8. Pin the opening (from where you turned the blanket) shut. Make sure to fold the edges under so it matches the rest of the blanket. The last thing you want is raw edges.
9. Top stitch close to the edge all the way around, including the opening.
10. Enjoy your new blanket! I’m sure the baby who receives it will :).